The Scanivalve M12 Push-Pull to RJ45 Ethernet Cable, Up to 5 ft (155035-04) is a custom-length Ethernet patch cable for compatible Scanivalve pressure measurement equipment. It provides an M12 Ethernet connection at one end and a male RJ45 connection at the other, with the required cable length specified when ordering up to a maximum of 5 ft.
Key Features
- Custom cable length up to 5 ft, allowing the required length to be specified when placing the order
- M12-to-RJ45 Ethernet connection, linking compatible Scanivalve equipment to a male RJ45 network interface
- Shielded Cat5e construction, supporting Ethernet communication in test and measurement installations
- Short installation cable option, helping reduce excess cable in compact equipment layouts
- Compatible Scanivalve system context, intended for supported ECM and DSA-PTP Ethernet connections
- M12 D-Code connector reference, with a four-pin Ethernet connector listed in the available Scanivalve catalogue context
- Clearly identified Scanivalve accessory, using part number 155035-04 for procurement and system configuration
Note: The required cable length must be specified before ordering. The supplied product record describes an M12 Push-Pull connector, while available Scanivalve references identify an M12 D-Code, four-pin connection. Confirm the required connector style and equipment compatibility before ordering.
Benefits
- Connect compatible Scanivalve equipment to an RJ45 network interface without assembling a custom cable on site.
- Minimise unused cable and simplify routing by selecting a length suited to the installation.
- Support organised test and measurement setups where space around scanners and control modules is limited.
- Make accessory identification and repeat purchasing easier through the dedicated Scanivalve part number.
Why Choose the Scanivalve M12 Push-Pull to RJ45 Ethernet Cable, Up to 5 ft (155035-04)?
The Scanivalve 155035-04 provides a convenient custom-length Ethernet connection for compatible Scanivalve pressure scanner and control module installations. Its M12-to-RJ45 configuration and maximum length of 5 ft make it suited to short, organised equipment connections. John Morris Group can assist with confirming the required cable length, connector style and equipment compatibility before ordering.
