- Convenient handheld design allows you to read PendoTECH Single Use Pressure SensorsT™
- Reads sensors to their specification of 0-6 psi +/- 2% of reading; 0-30 psi +/- 3% of reading
- Battery operated - Uses 9V battery (approximate 14 hours of power)
- No calibration required when used with the pressure sensors (the standardized sensor output signal is read)
- One-touch button for sensor tare at 0 psi
- Minimum / maximum pressure display buttons
- Auto shut-off after 10 minutes
- Display to x.x psi with updates >2X per second (x.xx upon request)
• Available for use with tubing from small scale to 1 inch inner diameter (available sizes are luer fitting; hosebarb with ¼, 3/8, ½, ¾, and 1 inch sizes); and sanitary flange
• Unobstructed flow path & no dead legs
• Qualified for use with no failure to -7 to 75 psi
• Compatible with gamma irradiation
• All materials meet USP Class VI
• Integral 12 inch cable connects to reusable cable via molded connector
• Each sensor is tested for quality and accuracy during manufacturing and rejected if out of specification (NO CALIBRATION REQUIRED!)
• Manufactured in a clean room in an FDAregistered, ISO 13485 facility
• Low cost
• Polycarbonate material or caustic resistant polysulfone
• Certificate of quality included with lot certification; individual NIST Calibration Certificates are optional
• May be non-invasively tested in-place via test port
Whats Included:
12-ft (3.7 m) re-usable cable.
