Model: MTS_HIGHTEMPCOMP - High Temperature Bend Test Components _1661215
Model: MTS_HIGHTEMPCOMP - High Temperature Bend Test Components _1661215
Model: MTS_HIGHTEMPCOMP - High Temperature Bend Test Components _1661215
Model: MTS_HIGHTEMPCOMP - High Temperature Bend Test Components _1661215
Representative image only

Model: MTS_HIGHTEMPCOMP - High Temperature Bend Test Components 

Overview

High Temperature Bend Test Components (Here are photos showing the 642.85 Bend Fixture in the 647.15S Single Zone Furnace)

To conduct 1600C Bend Tests, the 680.15S Grips are removed from the system and replaced with the components listed below:

MTS Model 642.85 High Temperature Ceramic Bend Fixture x 1

  • 1600C Bend Fixture 
  • Made of high quality silicon carbide. 
  • Bend test fixture per MIL spec 1942.
    • Distance between lower rollers: 40mm (1.57 inches).
    • Distance between upper rollers: 20mm (0.79 inches). 
  • Fully articulating design for use with as sintered or machined specimens. 
  • Maximum use temperature of 1600°C 
  • For 3mm * 4mm * 45 mm long ceramic specimens 
  • Fully articulated design

MTS Model 602 High Temperature Ceramic Pushrod Assembly x 1

  • SiC Pushrods extend into furnace 
  • Water Cooled SST Adapters mount to actuator and load cell 
  • Machined to accommodate integral 632.70 Bend Bar Extensometer

MTS Model 642.70 Bend Bar Extensometer x 1

This device provides direct measurement of specimen deflection as it references from specimen and measures the total deflection between the upper span on the bend fixture 

  • Strain gage based deflectometer utilizing the patented MTS cross flexure design. 
  • Uses three measurement rods, with the deflection measurement being the difference between the center rod and the outer rods. 
  • Provides for low activation force and minimal backlash. 
  • Measurement rods in silicon carbide. 
  • Designed to work with MTS Model 642.85 High Temperature Bend Fixture Specimen

WARRANTY: 12 Month Standard MTS Warranty applies to all the abovementioned Bend Test Components

Over 40,000 Customers Trust John Morris